Configuring Ethernet Settings

Ethernet is a standard for communicating data in a local area network (LAN). You can set the communication mode and the Ethernet type. In general, the machine can be used without changing the defaults (<Ethernet Driver Settings>), but you can change these settings to suit your network environment.

Display the <Menu> screen. Home Screen

Touch Panel Model

Select <Menu> in the Home screen.

5 Lines LCD Model

Press

Select <Network Settings>.

If the screen for entering a PIN appears, enter the correct PIN. Setting the System Manager PIN

Select <Ethernet Driver Settings>

<Auto Detect>.

Select whether to configure Ethernet settings automatically or manually.

If auto-detection is enabled, the machine detects and automatically sets the Ethernet communication mode and the type that can be used.

Configuring Ethernet settings automatically

Select <On> in <Auto Detect>.

Configuring Ethernet settings manually

1	Configure a setting to disable Auto Detect. Select <Off> in <Auto Detect>.
2	<Communication Mode> select the communication mode. <Half Duplex> Alternately sends and receives communication data. Select when the machine is connected to a networking device using half duplex. <Full Duplex> Simultaneously sends and receives communication data. Use this setting for most environments.
3	<Ethernet Type> select the Ethernet type.
4	Select <Apply>.

Changing the Maximum Transmission Unit

Setting a Wait Time for Connecting to a Network