Configuring SLP Communication

When using the machine in an environment using a Service Location Protocol (SLP) with software installed to perform communication, configure the SLP communication settings, as needed.
* See the manual of the software to determine the settings that need to be configured.
Configure these settings using Remote UI from a computer. You cannot use the operation panel to configure the settings.
Administrator privileges are required. The machine must be restarted to apply the settings.
Required Preparations
Prepare the port number used for SLP communication with the software and keep it close by.
Check the number of routers the SLP communication packets will traverse.
1
Log in to Remote UI in System Manager Mode. Starting Remote UI
2
On the Portal page of Remote UI, click [Settings/Registration]. Portal Page of Remote UI
3
Click [Network Settings] [Multicast Discovery Settings] [Edit].
The [Edit Multicast Discovery Settings] screen is displayed.
4
Select the [Respond to Discovery] checkbox, enter the scope name, and click [OK].
For the scope name, enter the name of the scope to which the machine belongs using single-byte alphanumeric characters.
5
Click [Network Settings] [Sleep Mode Notification Settings] [Edit].
The [Edit Sleep Mode Notification Settings] screen is displayed.
6
Select the [Notify] checkbox.
A notification of the power status of the machine is sent to the software. This helps reduce unneeded communication during sleep mode and power consumption.
7
Configuring Sleep Mode Notifications
[Port Number]
Enter the port number used for SLP communication with the software.
[Number of Routers to Traverse]
Enter the maximum number of routers that SLP communication packets can traverse.
[Notification Interval]
Enter the interval at which notifications are sent about the power status of the machine.
8
Click [OK].
9
Restart the machine. Restarting the Machine
The settings are applied.
84CS-06U