[Status Monitor] Screen

This screen is displayed when you press [Status Monitor] on the [Home] screen and other locations.
Use this screen to check the information of the machine, usage and logs, network settings, and error information. You can also use this screen to remove USB memory devices from the machine.
[Error Information/Notification]
You can check the information of errors that occur on the machine. Take troubleshooting measures according to the error details.
A Message Appears
An Error Code Is Displayed
[Device Information]
[Paper Information]
Check the remaining amount of paper for each paper source.
[Cartridge Information]
Check the remaining amount of toner in the toner cartridges.
Other internal parts may reach the end of their lifetime before the toner runs out.
[Check Counter]
Check the total number of pages printed, faxed, and copied. Checking the Number of Printed Pages (Check Counter)
[Secure Print Memory Usage]
Check to see how much memory is used by the Secure Print data temporarily saved to the memory of the machine.
[Version Information]
Displays the firmware version information of the machine.
[Serial Number]
Displays the serial number of the machine.
 
[Copy/Print Job]
Displays the copy or print processing status and log.
Checking the Copy Status and Log
Viewing the Print Job Status and Log
[TX Job]
Displays the status and log of sent and saved scanned data and faxes.
Checking the Send and Save Status and Log of Scanned Data
Checking Sent and Received Faxes
[RX Job]
Displays the status and log of received faxes and I-Faxes. Checking Sent and Received Faxes
[Fax Forwarding Errors]
If a fax could not be forwarded but remains in the memory, you can print it or forward it to a different destination, and view its content. Checking Faxes that Failed to Be Forwarded
[Network Information]
[IPv4]
Check the IPv4 address and other settings. Setting IPv4 Addresses
[IPv6]
Check the IPv6 address and other settings. Setting IPv6 Addresses
[Network Connection Type]
Check whether the machine has a wired or wireless connection.
Displays the connection status and error information when connected by wireless LAN.
[Direct Connection Information]
Displays the connection status when directly connected to a device.
[IEEE 802.1X Error Information]
Displays the details of errors that occur with IEEE 802.1X authentication.
 
[Rmv. Mem. Media]
Displayed when a USB memory device is connected. Press to remove the USB memory device. Removing the USB Memory Device
[IP Address]
Displays the IPv4 address of the machine by default. You can also hide this. [Display IP Address]
82H3-047