[Display Settings]

Configure the control panel screen displays.
* Values in bold red text are the default settings for each item.

[Menu] [Preferences] [Display Settings]

Specify the screen displayed after the start screen appears when the machine is turned ON and immediately after an Auto Reset.
Setting this for the [Status Monitor] enables you to also specify the screen displayed immediately after the [Status Monitor] screen is closed.

[Menu] [Preferences] [Display Settings]

Rearrange the buttons so that you can run frequently used functions more quickly from the [Home] screen of the control panel. Customizing the [Home] Screen

[Menu] [Preferences] [Display Settings]

Change the language shown on the control panel and used in printed reports.

* Depending on your country or region, the [Language] setting may not be available, or its content or default setting may be different.

[Menu] [Preferences] [Display Settings]

Change the language shown on Remote UI screens.

* Depending on your country or region, the [Remote UI Language] setting may not be available, or its content or default setting may be different.

[Menu] [Preferences] [Display Settings]

Change the units shown on the screen for entering length and width.

[Menu] [Preferences] [Display Settings]

When the toner in a toner cartridge runs low or the lifetime of the drum cartridge is close to end, a message appears notifying you to prepare a new toner cartridge or drum cartridge. To manually specify when this message appears (the toner level in a cartridge or how much the drum is used), specify the timing in [Custom].
When [Auto] is set, the machine automatically decides when to display the message.

[Menu] [Preferences] [Display Settings]

Specify whether to display the machine's IPv4 address in the [Status Monitor] screen. [Status Monitor] Screen

[Menu] [Preferences] [Display Settings]

Specify whether a message is displayed to notify you if soiling is detected during feeder use.