Front Side

Power switch

Turn ON and OFF the power of the machine. Turning ON and OFF the Machine

Paper drawer 1

Load frequently used paper. Paper Drawer

Waste toner cover

Open when replacing the waste toner container.

Paper drawer 2

Load frequently used paper. You can also load paper of a size that cannot be loaded in paper drawer 1. Paper Drawer

Control panel

Use the touch panel display to operate the machine and check its status. Control Panel

Feeder

You can place several sheets of originals in the feeder. Placed originals are fed and scanned one by one automatically. 2-Sided Single Pass Feeder

USB port (for USB devices) (front right side)

You can connect a commercial USB memory device or USB keyboard.

* Supports USB 2.0.

Right cover of the main unit

Open the cover when a paper jam occurs inside the machine.

Multi-purpose Tray

To temporarily use paper not loaded in the paper drawer, load it in the multi-purpose tray. Multi-Purpose Tray

Right cover of the paper drawer

Open this when a paper jam occurs.

Glass cleaning cloth storage box

Stores the glass cleaning cloth.

Platen glass

Place books, thick paper, thin paper, and other originals that cannot be placed in the feeder on the platen glass. Placed originals are scanned in a stationary state. Placing Originals

Front cover of the main unit

Open to replace the toner cartridge and drum unit, and to clean the LED printhead.

IMPORTANT

If you connect a device that exceeds the following power supply capacity provided by the machine to the USB port (for USB devices), the machine may be damaged.

Front right side: 5 V 500 mA

Rear right side: 5 V 900 mA

Do not forcefully push the feeder to close when placing a book, magazine, or other thick original on the platen glass.

NOTE

For details about the configuration of the machine when options are installed and the part names of the optional equipment units, see the following.

Supported Options

To ensure efficient use of the machine, clean the surface of the machine and platen glass regularly.

Cleaning the Surface of the Machine

Cleaning the Platen Glass

If the following symptoms occur when using the feeder, clean the feeder: Cleaning the Feeder

Originals become dirty

Originals frequently jam

Printouts appear smudged after scanning, copying, or sending faxes

Original size is not detected correctly