Settings/Registration] 
[Function Settings] [Printer] [Printer Settings] [Custom Settings] [Layout][Layout]
Set the binding location, margins, and print position.
* Values in red text indicate the default setting for each item.
[ Settings/Registration] [Function Settings] [Printer] [Printer Settings] [Custom Settings] [Layout]
Settings/Registration] [Function Settings] [Printer] [Printer Settings] [Custom Settings] [Layout]Set whether to bind the paper on the long edge or the short edge when the printed document will be bound using a method such as staples.
Configure this setting together with the [Gutter] setting to adjust the margin of the binding position. [Gutter]
Configure this setting together with the [Gutter] setting to adjust the margin of the binding position. [Gutter]
To bind the paper on the long edge, select [Long Edge].
To bind the paper on the short edge, select [Short Edge].
[Long Edge], [Short Edge] |
[ Settings/Registration] [Function Settings] [Printer] [Printer Settings] [Custom Settings] [Layout]
Settings/Registration] [Function Settings] [Printer] [Printer Settings] [Custom Settings] [Layout]Offset the print position to adjust the width of the margin that will form the gutter.
Specify the offset width in 0.5 mm (0.01") increments using a positive (+) or negative (-) value for the offset direction, in accordance with the edge specified in [Binding Location]. [Binding Location]
Specify the offset width in 0.5 mm (0.01") increments using a positive (+) or negative (-) value for the offset direction, in accordance with the edge specified in [Binding Location]. [Binding Location]
When [Binding Location] Is Set to [Long Edge]
Specify a positive (+) value for the offset width when you bind on the left edge of the paper, or specify a negative (-) value when you bind on the right edge.
When a positive (+) value is specified
When a negative (-) value is specified
When [Binding Location] Is Set to [Short Edge]
Specify a positive (+) value for the offset width when you bind on the top edge of the paper, or specify a negative (-) value when you bind on the bottom edge.
When a positive (+) value is specified
When a negative (-) value is specified
-50.0 to 0.0 to +50.0 (mm) (-1.90 to 0.00 to +1.90 (inches)) |
NOTE
When you adjust the creep or print position, the corresponding values are added to the offset width. [Creep Correction] and [Offset Short Edge] and [Offset Long Edge]
[ Settings/Registration] [Function Settings] [Printer] [Printer Settings] [Custom Settings] [Layout]
Settings/Registration] [Function Settings] [Printer] [Printer Settings] [Custom Settings] [Layout]Offset the print position for text and images. Configure these settings when text and images are printed off-center or outside the print range.
Specify the offset width in 0.5 mm (0.01") increments using a positive (+) or negative (-) value for the offset direction, for each paper edge direction and print side.
Specify the offset width in 0.5 mm (0.01") increments using a positive (+) or negative (-) value for the offset direction, for each paper edge direction and print side.
When Adjusting the Offset Along the Short Edge (Horizontally)
Specify the offset width as a positive (+) value to adjust the offset toward the right of the paper, or a negative (-) value to adjust the offset toward the left.
When Adjusting the Offset Along the Long Edge (Vertically)
Specify the offset width as a positive (+) value to adjust the offset toward the bottom of the paper, or a negative (-) value to adjust the offset toward the top.
-50.0 to 0.0 to +50.0 (mm) (-2.00 to 0.00 to +2.00 (inches)) |
NOTE
When you adjust the creep or gutter, the corresponding values are added to the offset width. [Creep Correction] and [Gutter]