Setting IPv4 Address
 |
|
The machine's IPv4 address can be either assigned automatically by a dynamic IP addressing protocol, such as DHCP, or entered manually. When connecting the machine to a wired LAN, make sure that the connectors of the LAN cable are firmly inserted into the ports (Connecting to a Wired LAN). You can test the network connection if necessary.
|
Setting IPv4 Address
1
Tap <Menu> in the <Home> Screen.
2
Tap <Network Settings>.
If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press 
. Logging on to the Machine
. Logging on to the Machine3
Select <TCP/IP Settings> 
<IPv4 Settings> <IP Address Settings>.
<IPv4 Settings> <IP Address Settings>.4
Configure IP address settings.
<Auto Acquire>Select to automatically assign an IP address via DHCP protocol. When <Auto Acquire: On> is displayed, automatic addressing is enabled.
<Manually Acquire>Select to configure the IP address settings by manually entering an IP address. In order to select this option, <Auto Acquire> must be set to <Off>.
<Check Settings>Select when you want to view the current IP address settings.
Automatically assigning an IP address
|
1
|
Select <Auto Acquire>
<Select Protocol>. |
|
2
|
Tap <DHCP>.
  If you do not want to use DHCP/BOOTP/RARP to assign an IP address
Tap <Off>. If you tap <DHCP> when these services are unavailable, the machine will waste time and communications resources searching the network for these services.
|
|
3
|
Check that <Auto IP> is set to <On>.
If <Off> is selected, change the setting to <On>.
|
|
4
|
Tap <Apply>.
|
IP addresses assigned via DHCP override the address obtained via Auto IP.
Manually entering an IP address
|
1
|
Check that <Auto Acquire> is set to <Off>.
 If <On> is displayed, tap <Auto Acquire>, and set both <Select Protocol> and <Auto IP> to <Off>.
|
|
2
|
Tap <Manually Acquire>.
|
|
3
|
Specify the IP address, subnet mask, and gateway address (or default gateway).
Specify the settings in the following order: <IP Address>
<Subnet Mask> <Gateway Address>.Enter each setting using the numeric keys, and tap <Apply>.
 |
5
Restart the machine.
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
 |
Checking whether the settings are correctMake sure that the Remote UI screen can be displayed with your computer (Starting Remote UI). If a computer is not available, you can check the connection by using the operation panel (Testing the Network Connection).
|
Testing the Network Connection
1
Tap <Menu> in the <Home> Screen.
2
Tap <Network Settings>.
If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press . Logging on to the Machine
. Logging on to the Machine3
Select <TCP/IP Settings> <IPv4 Settings> <PING Command>.
<IPv4 Settings> <PING Command>.4
Enter the IPv4 address of another device on the network, and tap <Apply>.
If a proper connection has been established, the result is displayed as shown above.