Registering Multi-Purpose Tray Defaults

This setting is useful if you always load the same paper size and type into the Stack Bypass-C, Stack Bypass Alignment Tray-D and Long Sheet Tray-B by registering the default paper size and type for the tray in advance.

This mode can be set when the Stack Bypass-C, Stack Bypass Alignment Tray-D and Long Sheet Tray-B are attached. (See "Stack Bypass-C.")

IMPORTANT
Be sure to correctly set the paper type. If the type of paper is not set correctly, it could adversely affect the quality of the image. Moreover, the fixing unit may become dirty and require a service repair, or the paper could jam.

Press

Press [Preferences] → [Paper Settings] → [Multi-Purpose Tray Defaults].

Press [On] → [Register].

If you do not want to register the setting, press [Off] → proceed to step 6.

Select the desired paper size.

If you want to select a standard paper size:

If you want to select a custom paper size:

If you want to select an envelope type:

If you want to select a standard paper size:

Select a paper size from <A/B Size> → press [Next].

NOTE
To select an inch paper size, press [Inch Size].

If you want to select a custom paper size:

Press [Custom Size].

Press [X] and [Y] → enter each value → press [OK].

You can also select a size key ([S1] to [S5]) containing a stored paper size setting, instead of entering values.

Press [Next].

If you want to select an envelope type:

Press [Envelope] → select the envelope type → press [OK].

IMPORTANT
If the envelope type is not set correctly, a paper jam will occur.

Press [Next].

Select the desired paper type → press [OK].

NOTE
[Transparency] can be selected only if you select [A4] as the paper size. For more information on paper types, see "Available Paper Stock." You can register paper types that are not displayed on the detailed settings list in <Paper Settings: Paper Type>. For instructions on registering paper types, see "Registering Custom Paper Types."

Press [OK].

NOTE
To use the Stack Bypass-C as a paper source for [Copy], [Access Stored Files], [Receive], or [Other], you must set so that the Stack Bypass-C is eligible for Paper Drawer Auto Selection. (See "Enabling Paper Drawer Auto Selection.")