Configuring a Printer Port (Windows Only)
If the IP address of the machine is changed or a printer has been added in Windows, you may not be able to print from a computer. In this case, use the printer driver to add a new port.
In addition, you cannot print from a computer when the port type of the printer driver differs from that of the machine setting. In this case, change the setting on the printer driver to match that of the machine.
In addition, you cannot print from a computer when the port type of the printer driver differs from that of the machine setting. In this case, change the setting on the printer driver to match that of the machine.
Adding a Port
The machine supports a standard Windows TCP/IP port. You must add a new port every time the IP address of the machine is changed.
Administrator privileges are required on each computer.
Required Preparations
Have the IP address or DNS name (host name) of the machine at hand. Checking the Network Status and Settings
1
Log on to the computer using an administrator account.
2
Click [
] (Start) 
[
] (Settings) [Bluetooth & devices] [Printers & scanners].
] (Start) [] (Settings) [Bluetooth & devices] [Printers & scanners].The [Printers & scanners] screen is displayed.
3
Click the printer driver of the machine [Printer properties].
[Printer properties].The printer driver properties screen is displayed.
4
On the [Ports] tab, click [Add Port].
The [Printer Ports] screen is displayed.
5
Select [Standard TCP/IP Port], and click [New Port].
The [Add Standard TCP/IP Printer Port Wizard] screen is displayed.
6
Click [Next].
7
Enter the IP address or DNS name (host name), and then click [Next].
The port name is entered automatically, so change it, as needed.
If [Additional port information required] Appears
Take action following the instructions on the screen. To set [Device Type], select [Canon Network Printing Device with P9100] in [Standard].
8
Click [Finish].
A new port is added, and the [Printer Ports] screen is displayed again.
9
Click [Close] [Close].
[Close].Changing the Port Type
If the machine is configured not to use LPD or RAW, you must change the type of port on the computer to a protocol usable on the machine.
* You do not need to change the port type on the computer for WSD ports.
Administrator privileges are required on each computer.
1
Log on to the computer using an administrator account.
2
Click [] (Start) [] (Settings) [Bluetooth & devices] [Printers & scanners].
] (Start) [] (Settings) [Bluetooth & devices] [Printers & scanners].The [Printers & scanners] screen is displayed.
3
Click the printer driver of the machine [Printer properties].
[Printer properties].The printer driver properties screen is displayed.
4
On the [Ports] tab, click [Configure Port].
The [Configure Standard TCP/IP Port Monitor] screen is displayed.
5
For [Protocol], select [Raw] or [LPR].
When [LPR] is selected, enter "lp" for [Queue Name].
6
Click [OK] [Close].
[Close].The settings are applied.