Setting the IP Address

There are the following three methods for setting the IP address.

 Setting the IP Address Using NetSpot Device Installer
Set the IP address using NetSpot Device Installer in the supplied CD-ROM.

 Setting the IP Address Using the ARP/PING Command
Set the IP address using the ARP/PING command in Command Prompt.

 Setting the IP Address Using the Printer Status Window
If the printer driver is installed and the printer and computer are connected by a USB cable, set the IP address using the Printer Status Window.
IMPORTANT
If Windows Firewall is enabled
We recommend that you set the IP address using the ARP/PING command or the Printer Status Window.
If you want to set the IP address using NetSpot Device Installer, you need to add "NetSpot Device Installer" to Windows Firewall in advance. Perform either of the following procedures.
Adding "NetSpot Device Installer" to the [Exceptions] sheet in the [Windows Firewall] dialog box
Readme of NetSpot Device Installer
To display the Readme, click [ ] in [NetSpot Device Installer for TCP/IP] in the [Additional Software Programs] screen in CD-ROM Setup.
Installing NetSpot Device Installer (You can add it to Windows Firewall during the installation.)
 "Installing NetSpot Device Installer"
NOTE
If you changed the IP address after installing the printer driver
Specify the port to be used again in the printer driver.
"When Changing the IP Address (Changing the Port)"
00AU-051