Manually Configuring the Ethernet Settings

By default, when the machine connects to a wired LAN, the Ethernet communication mode and Ethernet type are detected automatically, and these can be used without changes. Depending on the usage environment, you may have to change the Ethernet settings to suit the settings of peripheral devices.
* When the machine is connected to two wired LANs at the same time, the main line and sub line have separate Ethernet settings. You can change these settings, as needed.
 
This section describes how to configure the settings using the control panel.
You can also configure the settings using Remote UI from a computer. Managing the Machine from a Computer (Remote UI)】
Administrator or NetworkAdmin privileges are required. The machine must be restarted to apply the sub line settings.
1
Log in to the machine as an administrator. Logging In to the Machine
2
On the control panel, press [ Settings/Registration] in the [Home] screen or other screen. [Home] Screen
The [Settings/Registration] screen is displayed.
3
Press [Preferences]  [Network]  [Ethernet Driver Settings].
The [Ethernet Driver Settings] screen is displayed.
When Changing the Sub Line Settings
Press [Preferences]  [Network]  [Sub Line Settings]  [Ethernet Driver Settings].
4
Set [Auto Detect] to [Off].
5
Select the communication mode.
Normally, select [Full Duplex]. When the network router is set to half duplex communication, select [Half Duplex].
6
Select the Ethernet type, and click [OK].
7
Press [ Settings/Registration]  [Yes].
The settings are applied.
When the sub line settings are changed, the machine restarts automatically.
A0YC-17C