Connecting to a Wireless LAN by Setting the Details (Manual Setup Mode)

You can connect to a wireless LAN router by manually entering all information of the router such as the SSID (network name), network key (password), and security settings.
 
A wireless LAN connection requires Administrator or NetworkAdmin privileges.
Required Preparations
Prepare the information of the wireless LAN router to which you want to connect, and keep it close by. Wireless LAN Router Information Required for Connection
When connecting to a wireless LAN router using WPA-EAP, WPA2-EAP, or WPA3-EAP security standards, use IEEE 802.1X. Using IEEE 802.1X
1
Log in to the machine as an administrator. Logging In to the Machine
2
On the control panel, press [ Settings/Registration] in the [Home] screen or other screen. [Home] Screen
The [Settings/Registration] screen is displayed.
3
Press [Preferences]  [Network]  [Wireless LAN]  [Wireless LAN Settings].
The [Wireless LAN Settings] screen is displayed.
4
Press [Other (Set Manually)]  [Enter Manually].
The [Enter Manually] screen is displayed.
5
Press [SSID] and enter the SSID.
6
In [Security Settings], select the security standard, and set the authentication and encryption.
When using WEP
1
Press [WEP].
The [Security Settings] screen is displayed.
2
In [IEEE 802.11 Auth.], select the authentication method.
[Open System]
Uses open authentication.
* When you select this authentication method, an authentication error occurs when connected to a wireless LAN router that uses a shared key. The machine setting changes to [Shared Key] at this time, and an attempt to reconnect to the router is made.
[Shared Key]
Use a WEP key for the password.
3
Press any of [WEP Key 1] to [WEP Key 4], and enter the network key.
4
With the WEP key selected, press [OK].
The [Enter Manually] screen reappears.
When Using WPA-PSK, WPA2-PSK, or WPA3-SAE
1
Press [WPA/WPA2-PSK].
The [Security Settings] screen is displayed.
2
Select the encryption method.
When you select [Auto], AES-CCMP or TKIP is set automatically according to the wireless LAN router to which you want to connect.
3
Press [Encryption Key] and enter the network key.
4
Press [OK].
The [Enter Manually] screen reappears.
When Using WPA-EAP, WPA2-EAP, or WPA3-EAP
Press [WPA/WPA2-EAP].
When Not Using a Security Standard
Press [None].
7
Press [OK].
The connection starts.
If [Security Settings] is set to [WPA/WPA2-EAP], the message [The settings specified in IEEE 802.1X Settings will be applied to the connection.] is displayed. Press [OK] to start the connection.
8
When [Connected.] appears on the screen of the machine, press [OK].
9
Set the IP address.
Setting the IPv4 Address
Setting IPv6 Addresses
Setting the IPv4 Address of the Sub Line
NOTE
If an Error Message Appears during Operation and a Connection Cannot Be Established
Press [OK], check the information of the wireless LAN router to which you want to connect, and repeat the procedure starting from Step 4.
A0YC-176