When using the machine in an environment using a Service Location Protocol (SLP) with software installed to perform communication, configure the SLP communication settings, as needed. * See the manual of the software to determine the settings that need to be configured.
Configure these settings using Remote UI from a computer. You cannot use the control panel to configure the settings. Administrator privileges are required. The machine must be restarted to apply the settings.
Required Preparations
Prepare the port number used for SLP communication with the software and keep it close by.
Check the number of routers the SLP communication packets will traverse.
The [Edit Sleep Mode Notification Settings] screen is displayed.
6
Select the [Notify] checkbox.
A notification of the power status of the machine is sent to the software. This helps reduce unneeded communication during sleep mode and power consumption.
7
Configuring Sleep Mode Notifications
[Port Number]
Enter the port number used for SLP communication with the software.
[Number of Routers to Traverse]
Enter the maximum number of routers that SLP communication packets can traverse.
[Notification Interval]
Enter the interval at which notifications are sent about the power status of the machine.
This site uses cookies to provide its contents and functions and improve their qualities etc. You can find out more about our use of the cookies here. If you select "Reject", only cookies necessary to provide the contents and functions of the site are recorded and stored.