Loading Paper in the Multi-purpose Tray
|
Do Not Remove the Paper DrawerIf the paper drawer is removed, the machine cannot print even when paper is loaded in the multi-purpose tray. If you try to print with the paper drawer removed, an error message appears. |
1
Open the cover while holding both sides.
2
Pull out the paper tray.
3
Spread the paper guides apart.
While pressing the lock release lever, move the paper guides.
4
Fan the paper and align the edges.
Fan the paper in small batches, and align the edges by tapping the paper on a flat surface a few times.
5
Load the paper with the print side face up.
Insert the paper until the edge of the paper is against the paper tray.
Make sure the loaded paper does not exceed the load limit line (
). If it exceeds the load limit line, there may be misfeeds or a paper jam.
When Printing on the Back Side of Printed Paper (Manual 2-sided Printing)
Flatten the edge of the paper to remove any curls, and load the paper with the back (unprinted) side face up.
You can use only paper printed with this machine.
You cannot print on a side that has been previously printed on.
You cannot load more than one sheet of paper. Load each sheet separately to print.
6
Align the paper guides with the width of the paper.
While pressing the lock release lever, align the paper guides with the width of the paper.
Paper guides that are aligned but too loose or too tight can cause misfeeds or a paper jam.
7
By default, when the machine detects paper loaded in the multi-purpose tray, the screen for setting the paper size and type is displayed on the operation panel. Set the paper size and type each time you load paper.
|
When Loading A5 Size PaperSet the paper size according to the orientation of the loaded paper. | Landscape orientation (A5) | | Portrait orientation (A5R) | | | | |
|