Performing the Configuration Using the Printer's Control Panel (When You First Set it Up)
When configuring the startup waiting time using the printer's control panel, use the following menu hierarchy.
 | Pressing [  ] ( Settings) displays the common Setup menu. indicates that the procedure is performed by pressing [  ] or [  ] on the control panel.  indicates that the procedure is performed by pressing [OK] on the control panel. |
IMPORTANT |
After performing the configurationTo enable the settings, perform a hard reset or restart the printer. For details on a hard reset, see "Canceling All the Jobs (Hard Reset)." To go back up the hierarchy Press [  ] ( Back). About the control panelFor details on the control panel, see "Control Panel." |
1
Press [ ] (Settings), select [Network] using [ ] and [ ], and then press [OK].
] (Settings), select [Network] using [ ] and [ ], and then press [OK].When the message is displayed, press [OK].
| You can specify the settings when the printer is either online (the  Online indicator is on) or offline (the Online indicator is off). |
2
Select [Network Delay Time] using [ ] and [ ], and then press [OK].
] and [ ], and then press [OK].3
Specify the setting for startup waiting time using [ ] and [ ], and then press [OK].
] and [ ], and then press [OK].Set a delay of between 0 and 300 seconds from the time the printer is turned ON until it begins communicating.
4
Perform a hard reset or restart the printer.
After performing a hard reset or restarting the printer, the settings are effective.
NOTE |
For details on a hard reset |