1-sided Printing and 2-sided Printing

You can select whether to print on one side or both sides of each sheet of paper.
The default setting for [Print Style] is [2-sided Printing].

Paper Type	Paper Size
Plain paper (60 to 105 g/m²)	Standard size paper A3, B4, A4, B5, A5, Ledger (11 x 17), Legal, Letter, Executive, Foolscap, 8K and 16K Custom size paper: Short edges 148.0 to 297.0 mm, long edges 182.0 to 450.0 mm
Heavy paper (106 to 163 g/m²)
Coated Paper (100 to 160 g/m²)

Before performing 2-sided printing, see "Attention (1-sided Printing and 2-sided Printing)."

IMPORTANT

Precautions when performing 2-sided printing

Do not touch the paper during 2-sided printing until it is completely output. The paper is first partially output after the front side is printed, and then it is fed again to be printed on the back side.

Printing on the back side of paper that was previously printed (performing 2-sided printing manually)

The printer can manually print the back side * of paper that has been printed once.

When printing the back side of paper that has been printed once, first stretch out the edges and flatten out curls, load them one sheet at a time in the multi-purpose tray, and then perform the following operation with the printer driver.

1.	Display the [Paper Source] tab.
2.	Set [Paper Source] to [Multi-purpose Tray].
3.	Select the [Print on the Other Side] check box.

*	This is only for paper that has been printed using this printer. Also, you cannot print again on the same side of the paper that was printed before.

Click [Basic Settings].

For instructions on how to display the printer driver screen, see "Printing" or "Configuring the Default Print Settings."

Select [1-sided Printing] or [2-sided Printing] from [1-sided/2-sided/Booklet Printing]

NOTE
The default setting for [1-sided/2-sided/Booklet Printing] is [2-sided Printing]. You can also change the default setting to [1-sided Printing]. For instructions on changing the default settings, see "Configuring the Default Print Settings."

Select the binding edge from [Binding Location].

The output image is displayed in the preview area.

Click [OK].

NOTE
This function can also be set in the [Finishing] tab. The display may vary according to the operating system, as well as the type and version of the printer driver.